CLS Forklift Scale

Scale Carriage

• 28 in (Class II), 5,000 x 5 lbs, NTEP Certified

• 34 in (Class II), 5,000 x 5 lbs, NTEP Certified

• 38 in (Class III), 8,000 x 5 lbs, non-NTEP

• 1 1/2 in - thick front and back painted steel plates coupled by four flexures

• Top cleats are welded, pinned and bolted

• Welded centering pin

• Two 5,000 lb S-Beam load cells

• iQube2® junction box with inclinometer

• Molded coiled cable, up to 15 ft uncoiled

Presale Requirements

• Provide completed forklift questionnaire for quotation. A pre-installed load backrest on the forklift may interfere with flexures or cableless load cell interface option

• Compatible with most Class II and Class III forklift attachments, consult factory

• Required System InformationForklift carriage size (Class II, Class III, Other)
  Forklift carriage width (Is it greater than 36 in?)
  Does the forklift have a load backrest?
  Does the forklift have any existing attachments?
  Power supply for scale instrumentation (12 VDC, Other)
  Maximum mast extension (Under 180 in, Other)
  Any peripheral equipment needed (Example: Printer)
  

Installation Recommendations

• When installing a forklift scale on an electric forklift, static discharge protection must be present on the forklift and install a chasis mount power conditioner to protect forklift electronics.

• When installing a forklift scale, OSHA requires the end user to de-rate the lift capacity of the forklift.