AutoLift HE Hostile Environment Floor Scale
With its own pneumatic lifting arm, the low-profile AutoLift HE floor scale takes efficiency and safety further by providing hands-free access for washdown demands. The remote TuffSeal™ JB4SS stainless steel NEMA Type 4X junction box can be remotely mounted up to ten feet from the scale, keeping sensitive electronics far from damaging chemicals and moisture.
All of our floor scales, unless specified otherwise, are built with lifting holes to assist our dealers during installation, or to later service the scales. The lifting holes are not the same size on all of our scales and in the PDF in the Resources tab, you will find a chart that lists the standard size and quantity of eyebolts needed for our scales.
Features
Includes scale, pit frame, pit coping and pneumatic control box
Rugged washdown design
304 stainless steel construction
Rigid 304 stainless steel channel frame
Meets HACCP requirements
Manual, drop-in-place, safety bar
Four stainless steel, hermetically sealed, IP69K shear beam load cells
Load cells protected on all four sides
20 ft of SURVIVOR® hostile environment load cell cable
Remote TuffSeal® JB4SS stainless steel NEMA Type 4X junction box
Smooth stainless steel deck
Four adjustable stainless steel SUREFOOT™ support feet
Requires 85-100 psi air pressure, opens 43 degrees
Air lines and pneumatic regulator included;
conduit for load cell cable from junction box to indicator is not included
Specifications
End Load Capacity:
100% full scale at 2,000 lb and 5,000 lb
80% full scale at 10,000 lb
Cable Length:
20 ft (6.1 m)
Welding:
Stitch, consult factory if continuous is required
Threaded Eyebolt:
Hole (1/2-20 NF) located in center of deck for easy lifting
Warranty:
AutoLift HE weldment five years, load cells two years, all other components one year